#09 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z



Type: Driver
File Name: diy_cat4101_29751.zip
File Size: 19.9 MB
32 (4.82)
Downloads: 19
Supported systems: Windows 10, 8.1, 8, 7, 2008, Vista, 2003, XP
Price: Free* (*Free Registration Required)

Download Now


This diy cat4101 led uses a small amount of power. If you don't have other 5V or 3. For PWM control, you need to know if your controller is a current source, sink, or push-pull. The following is from the datasheet, and lists resistor values for specific LED currents. Ground: Creating a ground plane s on PCBs is a good practice.

10W LED Driver and Dimmer: 5 Steps (with Pictures)

Extra Capacitors: There are two extra capacitors on my boards that are not needed. RSET trimpot: If you are going to use these is a permanent project, and know exactly what current limit you want, the trimpot connected to RSET can be omitted. Special consideration should be given to diy cat4101 led LED power supply.

Series vs Parallel: When powering multiple high-power LEDs from a single driver, series is always preferred. A quick diy cat4101 led using the sample schematic on the CAT datasheet proves that the design works and lights up a test LED!

The key to this simplicity is the Arduinos pins, which are capable of both sinking and sourcing current. Not necessarily, if your input voltage is close to the forward voltage diy cat4101 led of the LEDs. For a microscope, light must go up….

Dificult to put the heatsink over the light source. Since the LEDs are generally driven around mA, that means that your power supply should be able to push 7 amps.

So the power diy cat4101 led you are looking at will get you there. Yea, I missed it to. If you need a better explanation let me know. The CATs do the regulation so to drive them all you needs is a constant voltage source. The key to this simplicity is the Arduinos pins, which are capable of both sinking and sourcing current. If diy cat4101 led move the part around to spread the paste a bit.

You do not need neat looking paste or exact part alignment at this point. When the joints reflow the surface tension of the solder will pull the paste back into the joints and align the part slightly to the pad. Take a look at the first and last picture on this diy cat4101 led. They are of the same 3 cards and should give you an idea on the amount of paste and the results. Depending on the paste and your oven the reflow diy cat4101 led and times will vary greatly.

10W LED Driver and Dimmer

I Made It! Internet of Things Class.

asus u30sd bluetoothRecommended Posts
liteon ltd 166sStep 2: Circuit
samsung scx 3405w wirelessPWM Dimming
usb-f3501Step 1: Some Math

Diy cat4101 led 3 years ago. Reply Upvote.Easy CAT LED Driver: As part of a larger home automation project in my small apartment, I wanted to make a LED lamp.

  • Simple 10 Watt LED Driver Is Hot Stuff Hackaday
  • Reef Central Online Community - View Single Post - DIY LED driver for reef lighting
  • DIY Steve's Leds driver circuit - Lighting Forum - Community
  • Easy CAT4101 LED Driver
  • Step 2: Bill of Materials
  • 10W LED Driver and Dimmer

This required making some LED. 10W LED Driver and Dimmer: This project came about from my need for a light The CAT datasheet includes the following table for setting LED current.

Related Posts